WINDOW / GLASS POWER WINDOW REGULATOR MOTOR(for Rear Door) REMOVAL
CAUTION / NOTICE / HINT
- HINT:
- ·
Use the same procedure for the RH and LH sides.
·The procedure listed below is for the LH side.
PROCEDURE
1. PRECAUTION
- NOTICE:
-
After turning the ignition switch off, waiting time may be required before disconnecting the cable from the battery terminal. Therefore, make sure to read the disconnecting the cable from the battery terminal notice before proceeding with work.
2.DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL
- NOTICE:
-
When disconnecting the cable, some systems need to be initialized after the cable is reconnected.
3.REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR UPPER ARMREST BASE PANEL LH
69284D
4.REMOVE REAR DOOR INSIDE HANDLE BEZEL PLUG LH
74646A
5.REMOVE DOOR ASSIST GRIP COVER LH
67604
6.REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY LH
67842E
7.REMOVE REAR DOOR SERVICE HOLE COVER LH
67408E
8.REMOVE REAR DOOR WINDOW DIVISION BAR SUB-ASSEMBLY LH
68124B
9.REMOVE REAR DOOR QUARTER WINDOW GLASS LH
68104
10.REMOVE REAR DOOR GLASS SUB-ASSEMBLY LH
69804
11.REMOVE REAR DOOR WINDOW REGULATOR SUB-ASSEMBLY LH
85720D
12.REMOVE POWER WINDOW REGULATOR MOTOR ASSEMBLY LH
Using a T25 "TORX" driver, remove the 3 screws and power window regulator motor assembly LH.
- NOTICE:
-
Be careful when removing the screws as the motor may fall and become damaged.
.png "close")